I bought a 1m x 1m 5500W but cannot see an image larger than a certain width/height nor can I scale/zoom it. Will this be fixed?
Also, some of the buttons (start, pause, reset...I think) are clipped.
Hi, is it possible to increase the voltage at the TTL line to use the full power of the laser. If i disconnect the TTL line, the laser is working with the full power.
I've the same problem. I work basically with images of 90cm X 90cm, but I can't do anything with the image, because it leaves the limits of the screen, I can't even zoom in.
Has there any way in cncc2019 to reduce the image before cutting, so I can have full visibility of it? I mean at the stage of loading image and working it.
Hello everyone!
it seems admin has better things to do than answering our questions ;)
I had the same problem, I have a 1mx1m 15W machine and when I had project this scale I couldn't see everything. I looked up everywhere on files and I found a solution:
1. Close "CNCC 2019.exe" software
2. Edit the file "gcn.ini" on the Notepad (you can find it at "English\CNCC2019 laseraxe software free of install, unzip and open CNCC.exe\CNCC2019 laseraxe software free of install, unzip and open CNCC.exe")
3. At line 2 you must have <px2mm>5</px2mm>*04/10/2018 14:12:27*
4. Turn the 5 into 2 (or 1) and save the file
5. Open "CNCC 2019.exe" software and the display scale might have changed
It works for me, I hope it'll work for you (tell me if it does)
I just downloaded the v1.09 version and the zoom still doesn't work. My technique seems to still work
Hello. Thank's for the tip. In fact, it worked. The CNCC2019, as an application for laser cutting, is worth almost nothing, especially in the section of image handling.