Contact

Customer Service:

laseraxe@hotmail.com

  • Black YouTube Icon
  • Black Facebook Icon
  • Black Instagram Icon
  • Black Twitter Icon
  • Black Facebook Icon
  • Black Instagram Icon
  • Black Twitter Icon
  • Black YouTube Icon

Newsletter

© 2014-2018 Laseraxe All rights reserved.

May 9, 2018

CNCC software(v2.50 and2.53) parameter default setting for laseraxe engraving machine

3 comments

Edited: Feb 23

Hi Guys, we know some one may change the CNCC software parameter settings which lead to the machine can not work normally. here is the software default parameter setting ensure you can recovery it. Just clicke CNCC "Settings" to change the parameter as the below picture then click "save" to finish it.

 

May 24, 2018

Just an FYI if you are getting burning when you outline, you need to change the "Default Value Set" to 1% in the Wea Power.

That only works with lasers with PWM. Anything 1000mW and lower do not have PWM. It's on or off.

Aug 28, 2018

A "Reset to Default" on this tab would be a nice feature.

New Posts