Recently bought a 15 watt laser. It is a ACAN A12 laser. It uses the Laseraxe mini board. I down loaded the CNCC 2019 software , but could not get it to work on any of my 3 different computers. So I down loaded the Laseraxe 2.53 and am using that right now. I glitches every once in a while, but at least it runs. When I bought it they said it supported GRBL. So I tried to run GRBL 3.0.9 and grbl will not work. I run GRBL on my other laser with a Arduino board and 5.5 watt laser and love it. Is there anything I can do to make the Laseraxe board run with the GRBL or am I going to have to use a different board? Amy help here would be greatly appreciated.