Contact

Customer Service:

laseraxe@hotmail.com

  • Black YouTube Icon
  • Black Facebook Icon
  • Black Instagram Icon
  • Black Twitter Icon
  • Black Facebook Icon
  • Black Instagram Icon
  • Black Twitter Icon
  • Black YouTube Icon

Newsletter

© 2014-2018 Laseraxe All rights reserved.

Jun 13, 2018

Manual Start Point

2 comments

There is a need to be able to move the system to a chosen start point in an engraving . so many times I have had to throw away blanks because the software crashed, or windows rebooted or some other reason, if I have a designated zero point for a project no matter the crash I can reset zero and the image size and settings, but to have the system go through the entire image a second time when it is a many many many many many hours project that has been corrupted,we need a way to fast forward to a point to restart, right now I am letting a project go on lowest burn time and lowest power , but it will be going for many hours before it gets where I need it to be,

attached is a picture of how far I have to wait

Jun 13, 2018

it is not burning, I have power and time set on minimum

 

Jul 21, 2018

Have you tried the advanced Settings? When you create Code, you can start at a line you enter.

But if your Image takes a Long time to be translated to g-Code, you shoud save the g-Code in the Program after it is generated. So you can jump directly to the Code tab and load it, set the line number and go. You can also stop the engraving, press pause when you have to time, and if you notice the line number, you can go on the next day.

English is not my native language, if i am explaining to complicated, please tell me.

New Posts