I am trying to use CNCC 2019 v.1.11 and have stated having trouble with the positioning of the head. When I run Range the head moves to the correct position where I want to engrave on my item but when I then Start the engraving it goes to a completely different location, not even on my item.
Search
I was having same issue to start. i tinkered i ended up picking a different corner for my zero point position. it seemed to kinda rectify that problem for me. not to sure if i just got lucky but it worked. im a newbie but thought i suggest it as something to try if your stuck still looking for a salutation.
see below, thanks
CNCC2019 no need to set zero point, just follow the manual to operate. move the laser head to z point. see attached photo.