Contact

Customer Service:

laseraxe@hotmail.com

  • Black YouTube Icon
  • Black Facebook Icon
  • Black Instagram Icon
  • Black Twitter Icon
  • Black Facebook Icon
  • Black Instagram Icon
  • Black Twitter Icon
  • Black YouTube Icon

Newsletter

© 2014-2018 Laseraxe All rights reserved.

Dec 9, 2018

using advanced picture mode leads to full power

1 comment

 

when i set the ttl power down and click on start then it goes up to 100% again......

i alwasy have to switch it down quickly after pushing start.

 

another problem is, that even when i limit the power to 1% or even 0% it burns the wood deeply in stead of drawing it. I can make it a little better when setting pixel-->millimeter to i higher number but that leads to interlaced drawing.

So if even 1% power is too high - what to do?

 

In primary mode reducing power and burning time works fine!!! so actually the power reduction in advanced mode is somehow not working well (although it makes some difference) ....I can change between strong burning and extremly strong burning ;-)

 

I have the 15 Watt module as i also want to cut plywood in dxf mode which works quite fine.

 

 

 

 

New Posts