Jan 19

Voltage at TTL line not more than 2,2 volt

Hi, is it possible to increase the voltage at the TTL line to use the full power of the laser. If i disconnect the TTL line, the laser is working with the full power.

0 comments0 replies

New Posts

Devin Miller
Feb 8
CNCC 2019 1.25 Errors
Question
Any time I click on black and white or outline for an image to engrave I get an emgu.cv.cvinvoke error. Any idea how to fix the error?
0 answers
0 replies
0
dmsato
Feb 8
New Laxeraxe setup can't connect to CNCC
Question
I just built my laseraxe laser engraving machine. I have installed the driver CH341SER.INF and software CNCC 2019 and the CNCC software will not connect. I have also tried to install the software CNCC V2.53 and also can't connect to the laseraxe machine. I received the message "COM4Did not make the right response. the connection has been disconnected." What am I doing wrong? Shouldn't it work? Does this sound like I have a defective control board?
1 answer
0 replies
0
info.magomusic
Feb 3
machine doesnt react for changing parameters of speed engraving .laseraxe cncc
Discussion
hi. i m using laseraxe cncc - tried to install the newest software after using 2.53C version - then i found F version and basiclly it still not responding good. I m changing in a CODE section - CurFeed as manuals say to do - and its not affecting speed.any ideas? i was playing with DefFeed also and power of burning. greetings
0 comments
0 replies
0

Laseraxe

Info

Support

Contact

Newsletter

Voltage at TTL line not more than 2,2 volt

CNCC 2019 1.25 Errors

New Laxeraxe setup can't connect to CNCC

machine doesnt react for changing parameters of speed engraving .laseraxe cncc