Dear friends, there was such a problem. I assembled the engraving machine and everything was fine until I started working with it. It engraves only diagonally. Two engines run synchronously.
Search
New Posts
- Hello! I have one of the LaserAxe systems (40"x40") and love it, however I recently started having issues with my system. It used to run smoothly but has begun to stutter when operating. It will do about 10 dots of etching then pause for several seconds before continuing. It only just started doing this and is SIGNIFICATLY increasing the time it takes to complete my etchings. I am usually etching leather and need a 51ms burn time at 60-70% power to get the desired result. I disconnected/reconnected every connection, uninstalled/re-installed the drivers, have it running on a dedicated machine with almost no other software programs besides the CNCC V2.53C Laseraxe software. Any ideas how to help? Is my laser just getting old/overused and needs to be replaced? Is there an updated software I should use that would help? Any advice is greatly appreciated
Make sure your setup has the correct settings. See the forum Setup parameters.
Everything is set right, it prints well, but diagonally, I do not know what to do
see https://www.laseraxe-customize.com/forum/cncc-software/cnc-software-parameter-default-setting
make sure your settings match if so then the wires to the stepper motors could be reversed.
I tried it, it still does not work out
how many stepper motors do you have?
2
OK so when you go to the "PIC/T" Tab in the earlier version of the CNCC software, the screen toward the bottom shows up/down arrows and left/right arrows. When you press up or down OR either left or right arrows (clicking the mouse arrow over these buttons) the machine goes diagonally??
I assume you are connecting to the software (by pressing autoconnect) to the machine board via your USB port on your computer. Correct?
as you said earlier all is true
can I contact you in Waths App
You need to contact THEM directly as it sounds like the board is not working correctly and you need a new one. Only THEY can get you a new board.
salve ragazzi,sapreste indicarmi come risolvere i problemi di connessione alla macchina?
la porta com tramite usb viene riconosciuta,
contattatemi se vi è possibile con wathsapp al 3477117908.
he said " hi guys, could you tell me how to solve the problems of connection to the machine? the com port via usb is recognized, contact me if you can with wathsapp at 3477117908. "
need more information I said
ho bisogno di più informazioni, ho detto