I have a laseraxe 40x60 from laseraxe from 2016. I have a some problems over 1 year. I send a couple of mails but the don't reacte/replay. So i hope this forum can help me. The laser works if connected direct to the 12V. But connect on the cnc it does not reacte or very very week. Most of the time -95% of the time- no laser dot.
When image is set and laser runs a RANGE is moves very smooth, but 2 the image size. When image set on 10x10cm the range runs almost 20x20cm.
When set the cnc on RUN, it shockes very hard and rappid white no laser dot.
what is the problem here?