Hi all, trying to figure out an issue ive been having with my laser cutter using laseraxe from the start. No matter how fast i set the print speed, the head speed of the laser is extremely slow, something like 100mm per min. please help.
Search
New Posts
- Hello! I have one of the LaserAxe systems (40"x40") and love it, however I recently started having issues with my system. It used to run smoothly but has begun to stutter when operating. It will do about 10 dots of etching then pause for several seconds before continuing. It only just started doing this and is SIGNIFICATLY increasing the time it takes to complete my etchings. I am usually etching leather and need a 51ms burn time at 60-70% power to get the desired result. I disconnected/reconnected every connection, uninstalled/re-installed the drivers, have it running on a dedicated machine with almost no other software programs besides the CNCC V2.53C Laseraxe software. Any ideas how to help? Is my laser just getting old/overused and needs to be replaced? Is there an updated software I should use that would help? Any advice is greatly appreciated
There are several places where the speed can be set. Where are you setting the speed?
Hi Friend, the Laseraxe just release its new CNCC software version, here is the downloading link:
https://www.dropbox.com/sh/lv5o0k74dn4r3bg/AAAjwXyX4lEDI7R3l7tpq_FOa?dl=0
come to download the latest version soft CNCC 2019, this version is better a lot than the old version:
https://www.dropbox.com/sh/lv5o0k74dn4r3bg/AAAjwXyX4lEDI7R3l7tpq_FOa?dl=0